Page 1 of 1
Accessing GUI on 8900-ax2400
Posted: Wed Dec 14, 2022 6:06 pm
by nozzer
I am using the above router in bridge mode and have a tp-link mesh attached to it. Since setting it up I can't access the 8900 GUI GUI any more, so is there a way to get at it directly from a mesh router, or maybe using a laptop connected to the bridge? Or is it a matter of doing a reset? If there is a written procedure could someone point me to it please?
Thanks in advance.
Re: Accessing GUI on 8900-ax2400
Posted: Thu Dec 15, 2022 9:17 am
by billion_fan
nozzer wrote: ↑Wed Dec 14, 2022 6:06 pm
I am using the above router in bridge mode and have a tp-link mesh attached to it. Since setting it up I can't access the 8900 GUI GUI any more, so is there a way to get at it directly from a mesh router, or maybe using a laptop connected to the bridge? Or is it a matter of doing a reset? If there is a written procedure could someone point me to it please?
Thanks in advance.
You need to connect directly the to 8900 with a static IP set on your LAN card, within the same range of the router
eg
PC LAN - 192.168.1.100
Billion Router - 192.168.1.254
Once set you can then login to the device on its IP address.
Re: Accessing GUI on 8900-ax2400
Posted: Thu Dec 15, 2022 12:30 pm
by nozzer
Thankyou. Thumbs up!