Port Forwarding Settings keep reverting
Posted: Wed Jul 22, 2015 9:07 am
Firstly, my apologies if this problem has already been discussed, but a search has revealed nothing similar.
My 7800N keeps reverting one particular Port Mapping setting back to an earlier value. Previously, I had Port 99 mapped to internal IP 192.168.1.2, but then needed to redirect it to 192.168.1.3. All works well for quite a while, but then the port mapping setting in the router reverts to the previous setting (.2).
I've not been able to establish if this occurs after a recycle of the router, but it's certainly not on every recycle. It may also be associated with the power-up of the earlier (.2) device, which is not normally switched on.
Before I launch into a detailed analysis of the cause, is anyone aware of this strange behaviour have occurred previously?
Thanks in advance.
My 7800N keeps reverting one particular Port Mapping setting back to an earlier value. Previously, I had Port 99 mapped to internal IP 192.168.1.2, but then needed to redirect it to 192.168.1.3. All works well for quite a while, but then the port mapping setting in the router reverts to the previous setting (.2).
I've not been able to establish if this occurs after a recycle of the router, but it's certainly not on every recycle. It may also be associated with the power-up of the earlier (.2) device, which is not normally switched on.
Before I launch into a detailed analysis of the cause, is anyone aware of this strange behaviour have occurred previously?
Thanks in advance.