Hi.
I'm trying to configure a 8800NL R2 router (software version 2.52.d15) to failover to the EWAN port, but can't find much information to get this working.
The setup would be:
Billion router using an FTTC connection as primary, auto-failover to a 4G router I have connected to the EWAN port.
Is this possible and how would I go about doing it?
The router is tested and working on FTTC, so it's just the additional config for the failover that is needed.
I appreciate that the Billion-8800AXL would likely be able to do this more easily with a dongle, but I have a quantity of 8800NL R2 routers and 4G rotuers that it would be very beneficial to get this config working on, if it's possible.
Thanks,
John
BiPAC 8800NL R2 - Help configuring failover on EWAN
-
- Posts: 2
- Joined: Fri Dec 13, 2019 11:11 am
-
- Posts: 5377
- Joined: Tue Jul 19, 2011 4:30 pm
Re: BiPAC 8800NL R2 - Help configuring failover on EWAN
I am assuming your 4G router will assign a IP to the Billion using its DHCP server, if so follow the steps belowJohnNaylor wrote: ↑Fri Dec 13, 2019 11:39 am Hi.
I'm trying to configure a 8800NL R2 router (software version 2.52.d15) to failover to the EWAN port, but can't find much information to get this working.
The setup would be:
Billion router using an FTTC connection as primary, auto-failover to a 4G router I have connected to the EWAN port.
Is this possible and how would I go about doing it?
The router is tested and working on FTTC, so it's just the additional config for the failover that is needed.
I appreciate that the Billion-8800AXL would likely be able to do this more easily with a dongle, but I have a quantity of 8800NL R2 routers and 4G rotuers that it would be very beneficial to get this config working on, if it's possible.
Thanks,
John
1. First setup a Ethernet >>> IP Over Ethernet connection (Configuration >> WAN >> WAN Service, make sure you set the IPOE connection to 'Selected Default Gateway Interfaces, and Selected DNS Server Interfaces when setting up the WAN interface )
2.Set the up Failover/Fallback with the 'Host' ping option used (as shown on the attahced screen shot)
That should be it, if the VDSL connection fails, it will failover to the EWAN connection, once the VDSL connection is back up it will fallback to the VDSL connection
You do not have the required permissions to view the files attached to this post.
-
- Posts: 2
- Joined: Fri Dec 13, 2019 11:11 am
Re: BiPAC 8800NL R2 - Help configuring failover on EWAN
Thanks Billion Fan!
That's exceptionally helpful. I've tested and got that working.
The speedy reply was much appreciated.
Cheers,
John
That's exceptionally helpful. I've tested and got that working.
The speedy reply was much appreciated.
Cheers,
John
-
- Posts: 5377
- Joined: Tue Jul 19, 2011 4:30 pm
Re: BiPAC 8800NL R2 - Help configuring failover on EWAN
That's great news mateJohnNaylor wrote: ↑Fri Dec 13, 2019 1:14 pm Thanks Billion Fan!
That's exceptionally helpful. I've tested and got that working.
The speedy reply was much appreciated.
Cheers,
John