Billion 6300nx slow and WIFI drops

Discussion for models not listed
Post Reply
newbuilder
Posts: 1
Joined: Mon Dec 26, 2016 9:08 am

Billion 6300nx slow and WIFI drops

Post by newbuilder » Tue Dec 27, 2016 7:36 pm

Hi

Recently bought two 6300nx for two sites. Both are having WiFi drop outs. They have improved since reducing the undernoted to the lowest values allowable.

Beacon Interval 100(range: 20~1000)
RTS/CTS Threshold 1500 (range: 1500~2347)
Fragmentation Threshold 256 (range: 256~2346, even numbers only)
DTIM Interval 1 (range: 1~255)
IGMP Snoop Yes
TX Power 100

The internet seems to stay up when WiFi drops.

Channel was set to Auto, I have manually set this to 12 but as there are no wifi signals in the area, a channel should not affect the performance?


The web interface is also painfully slow from wifi link on a laptop. This can take about 20 seconds to receive a signal from the router (webpage circle turning anti clockwise).

I have upgraded to latest Firmware then fac reset and rebuilt.

Any help gratefully received.

billion_fan
Posts: 4999
Joined: Tue Jul 19, 2011 4:30 pm

Re: Billion 6300nx slow and WIFI drops

Post by billion_fan » Wed Jan 04, 2017 12:22 pm

newbuilder wrote:Hi

Recently bought two 6300nx for two sites. Both are having WiFi drop outs. They have improved since reducing the undernoted to the lowest values allowable.

Beacon Interval 100(range: 20~1000)
RTS/CTS Threshold 1500 (range: 1500~2347)
Fragmentation Threshold 256 (range: 256~2346, even numbers only)
DTIM Interval 1 (range: 1~255)
IGMP Snoop Yes
TX Power 100

The internet seems to stay up when WiFi drops.

Channel was set to Auto, I have manually set this to 12 but as there are no wifi signals in the area, a channel should not affect the performance?


The web interface is also painfully slow from wifi link on a laptop. This can take about 20 seconds to receive a signal from the router (webpage circle turning anti clockwise).

I have upgraded to latest Firmware then fac reset and rebuilt.

Any help gratefully received.
Have you tried to change the Channel Bandwidth to 20mhz??

Post Reply