The 5200's web management port can only change via Telnet. From the Command Prompt type 'telnet 192.168.1.254' Password: admin sys server load sys server port web 81 sys server save Close the Command Prompt Power off the router for 10 seconds and ...
If you have a device which required to be on port 80 connecting from the outside over the Internet, and port 80 is normally the router's management interface by default. Then you need to change the router's management interface port to use another, perh...
First make sure you have a active internet connection (the internet
light should be green on the front of the Billion device)
1. Please change your LAN IP to the IP address your ISP said should
be assigned to the router, this is normally the second ...
In order to configure your 7800 series router to assign a fixed IP to
a networking device, you will need the follows:
1) The MAC address of the device
2) Decide a LAN IP address within the same subnet as your LAN but
outside the 7800 series route...
Once the save setting is completed, switch the router's power off for
10 seconds, and then power it back on agian. The computer/device
should receive the designated IP address from the router.
Login to 7700N http://192.168.1.254 (default).
If you selected 'Obtain IP address automatically' the below screen
may not appear, then just jump to step 25.
As we have been getting a lot of enquiries on
whether our routers can work with Be, I would like to share a list of our
routers tested working without problems. Testing has been done on 2 separate Be
lines, both on the Be Pro package (Annex M). One ...
Login to http://192.168.1.254 (default).
Save settings and the you will prompt to enter the new password set
to the router...
Click on the 'Apply' to save the new settings permanently (see
below).
Next click on the 'LAN' tab to enter the DNS details. To complete the process you must follows the steps below:
Next click on the 'LAN' tab to enter the DNS details. Follow the steps below to complete the process.
Check the system timer, if the time is incorrect, then click on the 'Sync Now' button to sync up the time with the time server.
How to set up the DMZ? Save settings.
Yes, you can set it to Advance mode every time you logged into the web GUI.
There are two ways to reset the router to factory settings: 1). Software factory reset via web GUI. 2). Hardware reset.
To change the router's IP address. Login to http://192.168.1.254
Login as 'Administrator'.
Once login then change the router's IP address.
After click on the 'Apply button, then you will see the below
message, please wait for 10 seconds.
Wh...
7700N portforwarding guide, please click to download.
