Knowledgebase : Network Address Translation (NAT)
Once you enabled the Half Bridge your Dynamic public WAN IP address will pass straight through the Router to the PC/device. To enable the Half Bridge mode see the document the instructions below. You must save the settings by follow the steps ...
74 Series NAT Loopback.For user on the local area network to connect to an internal web server using (www.myoffice.biz). We will need to configure the Router to take care of the extreme complicated issue arises due to NAT.The configuration steps are in tw...
1) For non-nat set up you need to add a rules in Packet Filter list. First you create a allow rule. 2) Disable the NAT. 3) Enter one of the public IP address to the router (this is usually specified to you by your ISP). Once you change the rou...
In a DMZ configuration, most computers on the LAN run behind a NAT  connected to a public network like the Internet. Only one computer/device is allow to be DMZ. And then you must save the new settings.
When the PPP Half Bridge is enabled the Bipac 5200xx becomes invisible. The DHCP server will duplicate the WAN IP address from the ISP to the local client PC. Only one PC is able to access the Internet using half bridge mode. Configuration Login to http...